Introduction
Mobile phone charging coils are an essential component that allows your device to charge properly. Over time, these coils can become damaged or worn out, resulting in charging issues. If you’re experiencing problems with your phone not charging or charging slowly, replacing the charging coil may be the solution. In this DIY guide, we’ll walk you through the steps of replacing a mobile phone charging coil.
Step 1: Gather the necessary tools
Before you begin the replacement process, make sure you have all the tools you’ll need. Here’s a list of the basic tools required:
- Screwdriver set
- Tweezers
- Heat gun or hairdryer
- Replacement charging coil
- Adhesive
Step 2: Prepare your workspace
Find a clean, well-lit area to work on your phone. Make sure you have enough space to lay out the tools and components without any risk of them getting lost or damaged. It’s also a good idea to have a small container to store the screws during the disassembly process.
Step 3: Disassemble your phone
Start by turning off your phone and removing the back cover. Use the screwdriver set to remove the screws holding the back cover in place. Once the screws are removed, gently pry off the back cover using a plastic opening tool or your fingernail.
Next, locate the charging port assembly inside your phone. It’s usually connected to the motherboard with a ribbon cable. Carefully disconnect the ribbon cable using the tweezers or your fingers. Be gentle to avoid damaging the cable or other components.
Step 4: Remove the old charging coil
Once the charging port assembly is disconnected, you’ll need to remove the old charging coil. This may require using a heat gun or hairdryer to soften the adhesive holding the coil in place. Apply heat to the area around the coil for a few seconds, then use the tweezers to carefully lift and remove the old coil.
Step 5: Install the new charging coil
Take the replacement charging coil and apply a small amount of adhesive to the back. Carefully position the coil in the same location where the old one was removed. Press it down gently to ensure proper adhesion.
Step 6: Reassemble your phone
Once the new charging coil is in place, it’s time to reassemble your phone. Reconnect the ribbon cable to the charging port assembly and secure it in place. Replace the back cover and tighten the screws using the screwdriver set.
Step 7: Test your phone
After reassembling your phone, turn it on and check if the charging issue has been resolved. Plug in your charger and ensure that the battery icon indicates it’s charging. If everything is working correctly, congratulations! You’ve successfully replaced the charging coil in your mobile phone.
Conclusion
Replacing the charging coil in your mobile phone can be a cost-effective solution to resolve charging issues. By following this DIY guide, you can save money and extend the life of your device. However, if you’re not comfortable with DIY repairs or if your phone is still under warranty, it’s always best to seek professional assistance. Remember to exercise caution and take your time during the replacement process to avoid any further damage to your phone.
